Plumbing is not complex if you know how!

The plumbing inside your manufactured home isn’t as complex as it may seem. People are very intimidated when it comes to the plumbing inside a manufactured home. With this article I will give you some pointers which will have the ability to help you with the water system in you manufactured home.
The water lines for the house will run in the underbelly and will often run along side of the duct work of your dwelling. The most important line which connects to the houses piping is conducted below the under belly and can be seen when you remove the skirting access panel. This line will usually be wrapped in insulation and heat taped if you live in colder climates.
There are many reasons why people may fear the plumbing system of a manufactured home. One is because it can be extremely hard to discover a licensed plumber to work on your dwelling. The reason for this is a good deal of plumbers are intimidated and don’t have the knowledge or appropriate fittings to work on home so it’s just easier for them not to mess with them.
In boiler installation may observe galvanized or aluminum pipe which may not be quite as intimidating, however many people have never seen polybutylene piping that’s common in houses built in the mid seventies to the mid to late 90s. Polybutylene or Poly piping is a usually a grey or black tube made out of a plastic material called polybutylene. This is a very inferior pipe that has been recalled because of the many leaks which happen because the pipe just simply wears down. Poly pipe also is very hard to deal with because it’s very unlikely you’ll be able to find the appropriate fittings to find the pipe back together again once you need to cut it to fix a leak. We will get into repairing a leak on poly piping but allow ‘s get into the various sizes of manufactured home water pipe .

The size of the piping in these homes might not be what you are accustomed too. Oftentimes you will have an odd ball dimensions. In these cases you’ll have a very difficult time finding the proper fittings. When you encounter this sort of problem you will have an easier time locating 3/8 and A PEX fittings so my advice would be to convert from 3/8 poly into 3/8 PEX using the proper conversion coupling that you can find at a house store.
In the case you have a flow on poly piping, the most common practice to fix it now would be to convert it to PEX piping. To convert a poly pipe into PEX pipe you’ll require a fitting called a PEX to Poly coupling. These are extremely easy to find and are at many of the big box home stores. Cut the pipe and splice in the new coupling using standard PEX fastening procedures. If you’re unaware on how to do PEX pipe you can discover various articles on the world wide web to assist you with this clinic.
I have found with all types of manufactured home water pipe it is easier to convert it to PEX pipe. With PEX pipe you can do whatever you will need to do to receive your homes water up and running again. PEX pipe is also the material of choice when re water piping your home. Typically you can run from 1 end to another without having to make to a lot of holes in the underbelly. You can also save yourself some frustration by re water pipping you home from the upper side of the home. In many cases we have pulled the carpet back and cut holes s in the floor beside the duct and have been able to water pipe an entire house by cutting three holes in the ground. Keep this option in your mind especially when you’re renovating you home and contemplating new water pipe.

0 Shares

Leave a Reply

Your email address will not be published. Required fields are marked *